Ariston Fridge/Freezer Combined Dokumentacja Strona 12

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 43
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 11
Merloni Elettrodomestici
FULL NO FROST COMBINED UNIT (2003)
Technical Manual
GB 04-10-28/01 12-43
Language Issue/Edition Page
4 ANALYZING THE LOADS
1. Compressor
The compressor, managed by the electronic board, is normally on when at least one of
the two compartments demands refrigeration, i.e., when the temperatures of the freezer
and/or refrigerator air sensor are such as to activate at least one refrigeration demand.
When both compartments no longer need refrigeration, the refrigeration demands are
deactivated and the compressor is switched off.
There are particular situations when, despite demands for refrigeration by the
appliance's compartments, the compressor remains switched off.
Compressor protection: in particular the compressor switches on 8 minutes after
it has been switched off. This allows the gas pressures inside the thermodynamic
circuit to equalize without risk of the compressor becoming blocked due to too high
pressures inside the thermodynamic circuit.
Long periods of activity: if the compressor remains on for more than 4 hours it is
switched off, even if the compartments demand refrigeration.
Pause after defrost: at the end of every defrost, the compressor observes
10 minutes of protection so that the water formed can completely run off before
the evaporator starts to cool again.
POSSIBLE CAUSE OF MALFUNCTION:
Electronic board management
Compressor control circuit on the board
Connection on the board
Wiring harness
Connection on the compressor
Breakages/anomalies inside the compressor
Temperature sensors open or short-circuited
TESTING:
General on appliance: force the compressor to switch on by activating the
24h SUPER FREEZE function and check that the compressor switches on.
(Remember the 8 minutes of compressor protection).
Wiring: check for continuity and short circuits; check the connections (connectors and
terminals); check whether voltage is available.
Component: check that the component is fed; direct check of the compressor
(powered directly).
Electronic board: carry out a quick visual check of the board (breakages or burnouts,
etc.); check by using a replacement.
Przeglądanie stron 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 42 43

Komentarze do niniejszej Instrukcji

Brak uwag